The video demonstrates how to build a router table using leftover plywood and scrap materials. The project begins with sketching the design, then proceeds to cutting the pieces using a table saw or circular saw. The table consists of a base, top, and fence, which are assembled using glue and screws. A small storage compartment is added to the bottom for storing router bits. The router is attached to the tabletop using screws and a plate, and a dust port is created for easy vacuum attachment. The table is sanded and finished with a paste wax. The completed router table is portable and can be used in various settings, making it a convenient addition to any woodworking setup.
Here are the key facts extracted from the text:
1. The project is to build a router table.
2. The table is approximately 16 inches high, 16 inches wide, and 10 inches deep.
3. The table is made from scrap pieces of plywood left over from previous projects.
4. The majority of the cuts were made on a table saw, but a circular saw can also be used.
5. A speed square is used as a guide for cross cuts, and the guide that comes with the circular saw is used for rip cuts.
6. The fence is made up of two parts: the base and the face.
7. The face of the fence can be left as is or have the corners cut off for aesthetics.
8. The base and sides of the table are glued and screwed together, with countersunk screws.
9. A dial rod is used to plug the screw heads so they are not visible.
10. A small bit storage is added to the table, with holes spaced to fit the bits.
11. The holes are drilled straight up and down to accommodate the bits.
12. The router table top is attached to the base using brackets, allowing for easy removal and adjustments.
13. The router is attached to the tabletop using screws long enough to compensate for the thickness of the plywood.
14. A plate is placed in the top of the router table to provide a flat surface for the router.
15. Slots are cut in the router table to accommodate the screws that hold the router in place.
16. The fence is attached to the table using screws, and a chamfer is added to the fence to prevent sawdust from accumulating.
17. The table is finished with paste finishing wax to reduce friction between the table and fence.
18. A dust port is added to the table to accommodate a vacuum attachment.
19. The table is designed to be portable and can be used in various locations, including construction sites.
20. A Dewalt cordless trim router is used with the table.