The video is a DIY guide to building a deck. The narrator starts by introducing the project and explaining the importance of choosing the right location for the deck. He decides to place the deck in the center of the yard, which requires removing a fire pit and a bench.
The narrator then begins the preparation work by laying out the deck frame and using a miter saw to cut the boards to size. He uses a weed barrier to kill the grass underneath the deck and prevent it from growing back.
The narrator then focuses on building the deck frame, using 3-inch deck screws to attach the joists to the frame. He also uses clamps to hold the frame in place while he works.
Once the frame is complete, the narrator adds the joists and uses a laser level to ensure the deck is level. He then adds the posts and fills the holes with concrete.
The narrator also builds a step to connect the deck to the yard, using drainage rocks to prevent water from accumulating. He attaches the step to the deck and adds two posts to support it.
The video ends with the narrator adding the finishing touches to the deck, including a weed barrier and joist tape. He also mentions that the next part of the video will cover adding the deck boards, fascia boards, and lighting.
Overall, the video provides a detailed guide to building a deck, including preparation, frame building, and adding the finishing touches.
Here are the key facts extracted from the text:
1. The size of the backyard is approximately 80 feet by 35 feet.
2. The deck is around 16 feet by 12 feet.
3. The plan is to put the deck in the center of the yard.
4. The author has to remove the fire pit and the bench from the location.
5. The author uses a weed barrier to kill the grass under the deck.
6. The author wants a clean and modern design with no joints at the top of the deck.
7. The materials for the deck have to be longer, which adds more weight.
8. The author uses a miter saw station to make repeatable cuts.
9. The author uses three-inch deck screws to assemble the deck frame.
10. The author uses joist hangers as an alternative to deck screws.
11. The final product of the deck will have a bit of an angle to it.
12. The author uses Trex decking, a composite material, on top of the structure.
13. The minimum requirement for Trex decking is 16 inches on center.
14. The author adds three screws per joist on each side.
15. The author is located in Florida, which is a warm climate with no frost issues.
16. The author digs holes for the posts, with an average depth of 15-24 inches.
17. The author adds gravel in the holes for drainage.
18. The author compacts the dirt within the holes using a piece of lumber.
19. The author uses marking spray to mark out the area for the step.
20. The author removes a section of grass and some of the dirt to make the step level.
21. The author uses a level to ensure the deck is level.
22. The author uses a laser to double-check the level of the deck.
23. The author measures diagonally across the deck to check if it's square.
24. The author adds posts on the inside of the deck to provide additional support.
25. The author fills the holes with drainage rocks and concrete.
26. The author uses a hand saw to cut off the suspended end of the deck.
27. The author applies joist tape to protect the joists and beams from rotting and extend their life.
28. The author uses a commercial-grade weed barrier to prevent weeds from growing under the deck.
29. The author staples the weed barrier to the deck and uses landscape fabric pins to hold it to the ground.