The speaker is building a backlit LED panel for a TV, which will be part of a future entertainment center. They start by cutting a piece of birch plywood to the desired size, then create a frame using pocket holes and wood glue. The frame is attached to the plywood, and the edges are covered with edge banding.
The speaker then installs the French cleat system, which is used to mount the TV to the wall. They measure and mark the location of the studs, then drill holes and attach the cleat to the wall. The TV is mounted to the cleat, and the speaker adjusts the spacers to ensure the TV is level.
Next, the speaker adds an outlet behind the TV, which requires cutting a hole in the wall and running electrical wires. They use a fish tape to guide the wires through the hole, then attach them to the outlet and test it with a simple tester.
The speaker then installs Wi-Fi LEDs around the frame of the back panel, using hot glue to secure them in place. They also add an extension cord to power the TV, LEDs, and cable box.
Finally, the speaker tightens up the outlet and adds screws to secure the panel to the wall. They place the LED controller in a convenient location and control the LEDs using their phone.
The video is sponsored by Vikings War of Clans, and the speaker encourages viewers to download the game and support their channel.
1. The creator is making a backlit LED panel for their TV.
2. The panel is part of a future entertainment center.
3. The creator is using birch plywood for the project.
4. The plywood is cut from one sheet.
5. The creator uses a pocket hole jig to drill holes for the frame.
6. The frame is initially 2.5 inches thick but is later cut down to 1.25 inches.
7. The creator uses a French cleat to mount the TV.
8. The TV bracket has two safety locks.
9. The creator adds an outlet behind the TV.
10. The creator uses Wi-Fi LEDs for the project.
11. The LED strip is wrapped around the entire frame of the back.
12. The creator uses hot glue to secure the LED strip.
13. The creator uses a stud finder to locate the studs in the wall.
14. The creator drills into the wood to create a flat surface for the screws.
15. The creator uses a toggle bolt to secure the other end of the French cleat.
16. The creator turns off the breaker before working with electrical wires.
17. The creator uses a wire nut to connect the wires.
18. The creator tests the outlet before hooking up any devices.
19. The creator uses a simple tester to check the outlet.
20. The creator controls the LEDs via their phone.
21. The creator is planning to build an entertainment center.
22. The creator is sponsored by Vikings War of Clans.