Here is a concise summary of the provided transcript:
**Project:** Customizing an Electric Scooter (MM In 65)
**Initial Issues:**
1. **Visibility**: Not flashy enough, lacking sufficient safety features (lights, reflectors)
2. **Comfort**: Insufficient shock absorption with current wheels and inner tubes
3. **Security**: Difficulty securing the scooter with a chain
**Customization Steps:**
1. **Visibility Upgrade**:
* Applied fluorescent yellow paint for increased visibility
* Added reflective materials
2. **Comfort Enhancement**:
* Replaced wheels with new 10-inch tires for better stability and shock absorption
* Utilized 3D printed parts to facilitate the change
3. **Security Solution**:
* Designed and 3D printed a custom part to enable secure chaining
* Added a rearview mirror for enhanced safety
**Outcome:**
* Successfully modified the scooter, addressing all initial issues
* Improved visibility, comfort, and security features
* Final result showcased with the scooter performing well, especially on rough terrain and in wet conditions, with additional LED strip lighting for extra visibility.
Here are the key facts extracted from the text, each with a number and in short sentences, excluding opinions:
**Scooter and Modifications**
1. The scooter model is MM in 65.
2. The scooter has a lithium material battery, 37V, 4.74Wh.
3. The scooter has an on-board computer with power supply.
**Initial Issues and Solutions**
4. The scooter initially lacked visibility.
5. The scooter initially had no secure locking point.
6. The scooter's wheels had inner tubes, affecting comfort.
**Modification Process**
7. The modification process took approximately 2 hours for wrapping.
8. Fluorescent yellow paint was used to increase visibility.
9. The scooter was dismantled to paint and modify parts.
**New Parts and Upgrades**
10. New 10-inch tires were installed for greater stability.
11. 3D printed pieces were created to adapt to the new tires.
12. A rearview mirror was added for increased safety.
13. New screws and accessories were obtained for reassembly.
**Reassembly and Final Touches**
14. Reassembly included reattaching the mudguard and stand.
15. LED strips (5V, USB) were added for extra visibility.
16. The LED strips were connected from red to red and black wires.