Here is a concise summary of the content:
**Project:** Building a Multi-Functional Sofa
**Key Features:**
* Converts into a chaise longue bed
* Storage underneath
* Coffee table
* No specific metal hardware used for flipping mechanism
**Summary of the Build Process:**
* Designed and planned with sketches and small-scale models
* Built using 2 sheets of 21mm birch plywood, primarily with a circular saw and drill
* Utilized a doweling jig for joining pieces
* Added a drawer with hidden screws and a custom fitting mechanism
* Incorporated a pivoting backboard for conversion to bed mode, secured with magnets and dowels
* Finished with acrylic matt varnish and upholstered with foam and custom-sewn fabric
**Outcome:**
* Successfully created a sturdy, multi-functional sofa with unique design details born from overcoming mistakes
* Plans available for viewers, sponsored by Rockler.
Here are the key facts extracted from the text, each with a number and in short sentences:
**Project Overview**
1. The project is to build a sofa that converts into a chaise longue, bed, with storage underneath and a coffee table.
2. The sofa's width is approximately 1 meter, designed to fit a specific space near a desk.
**Materials and Tools**
3. The project primarily uses 2 sheets of 21mm birch plywood.
4. Essential tools needed are a circular saw and a drill.
5. Additional tools used (but not necessary) include a table saw, router, and various clamps.
6. A doweling jig from Rockler was utilized for joining pieces.
7. 3/8th (9.5 mm) dowels were used for gluing pieces together.
**Construction Process**
8. Initial cuts were made at a lumber store, with further sizing adjustments made afterwards.
9. A bar clamp was used to navigate tight spaces during clamping.
10. The bottom module's back was closed, and a pencil line method was used for precise doweling.
11. For the drawer, scraps of plywood and hardboard were repurposed.
12. A table saw (used outdoors to minimize dust) was used to cut drawer components.
13. A rabbet joint was created for the drawer sides, using pin nails and screws (later covered).
14. Hardwood strips were added to the middle of the large drawer for support.
15. The drawer's inner components were painted white to match aesthetic details.
**Mechanism and Finishing**
16. Strips were added to level the top of the module for bed mode.
17. A pivot point was carefully selected to preserve sitting surface area and minimize gaps.
18. Magnets were used to connect triangles for stability, with a small dowel added to prevent sliding.
19. Four coats of acrylic matt varnish were applied, with light sanding in between.
20. Foam (8 cm, good quality) wrapped with polyester batting was used for the cushions.
21. Spray adhesive was used to stick materials together, and an old floor cushion was studied for sewing insights.
**Completion and Outcome**
22. The project was completed with a unique, foldable mattress design to prevent cushion movement.
23. Initial mistakes were incorporated into the design, giving the piece a unique look.
24. The sofa is sturdy for its intended purpose and fulfills the multi-functional design goal without specific metal hardware.